Articles

How do you test long-lived assets for impairment under ASC 360?

In two steps, only when a trigger appears: compare the asset group's carrying amount with its undiscounted cash flows, and if they fall short, write the group down to fair value.

Under ASC 360-10, assets held and used are tested for impairment only when events suggest their carrying amount may not be recoverable. The test runs on an asset group: if its undiscounted cash flows are below its carrying amount, the group is written down to fair value. In the worked case, a line carried at $4,100,000 with $3,430,000 of undiscounted cash flows and a fair value of $2,860,000 takes a $1,240,000 impairment loss.

Worked in full in The Fixed Asset Accounting Handbook by Julian R. Sterling, with every figure reproduced in a free workbook.Get the PDF, $19.99 →or the paperback

Step 0: a trigger

Long-lived assets held and used are not tested on a calendar. They are tested when events or changes in circumstances indicate that the carrying amount may not be recoverable (ASC 360-10-35-21): a significant adverse change in how an asset is used or in the business climate, operating losses with a history of losses, costs well above budget for an asset under construction, or an expectation that the asset will be disposed of significantly before the end of its life.

The case is a fictional plastics molder, Kestrel Molded Products. Its Line 3 makes automotive trim for one customer, Varden Automotive, which announced in August 2025 that its program ends in December 2026. The line's operating cash flow was already down 38% year on year. Kestrel ran the test at 30 September 2025.

Step 1: define the asset group

The test is run at the lowest level at which identifiable cash flows are largely independent of other assets (ASC 360-10-35-23). Line 3's presses, molds and robots serve only the Varden program and its revenue and costs are tracked separately, so the line is the asset group. The shared building is not part of it.

Line 3 at 30 September 2025
AssetCostAccumulated depreciationCarrying amount
Presses4,240,0001,590,0002,650,000
Robotics and automation1,400,000560,000840,000
Molds1,220,000610,000610,000
Line 34,100,000

Step 2: the recoverability test (undiscounted)

Compare the carrying amount with the sum of the undiscounted cash flows expected from the group's use and eventual disposal, over the remaining life of its primary asset (ASC 360-10-35-17 and 35-31). The projection runs to the end of the program:

Operating cash flow, October 2025 to December 2026: 2,180,000

Sale of the presses at the end: 1,250,000

Undiscounted cash flows: 3,430,000, against a carrying amount of 4,100,000: shortfall 670,000

The group is not recoverable. Had the cash flows exceeded the carrying amount, no loss would be recorded, however low the fair value; the company would only shorten the remaining lives.

Step 3: measure the loss at fair value

The loss is the excess of the carrying amount over fair value, measured under ASC 820. Dealer quotes priced the presses at 2,300,000; a cost approach valued the specialized molds and robots. The group's fair value is 2,860,000 (a Level 3 measurement), so the impairment loss is 4,100,000 - 2,860,000 = 1,240,000, or 930,000 after tax at a 25% rate.

Step 4: allocate the loss, with a floor

The loss is spread over the group's long-lived assets pro rata on carrying amounts, but no asset goes below its own fair value when that value can be determined without undue cost (ASC 360-10-35-28). A purely pro rata share would give the presses 801,463.41 of loss and take them to 1,848,536.59, below their 2,300,000 fair value. Their share is capped at 350,000, and the remaining 890,000 goes to the molds and robots in proportion to their carrying amounts.

Allocation of the 1,240,000 loss
AssetCarrying amountLossNew cost basis
Presses (fair value floor)2,650,000350,0002,300,000
Molds610,000374,413.79235,586.21
Robotics and automation840,000515,586.21324,413.79
Line 34,100,0001,240,0002,860,000

Step 5: new cost basis, new depreciation, no reversal

The written-down amounts become the new cost bases (ASC 360-10-35-20) and are depreciated over the remaining 15 months: the presses down to their expected sale price of 1,250,000, the molds and robots to zero. Line 3's depreciation for the fourth quarter of 2025 is 322,000.00. If fair value later recovers, nothing is written back under US GAAP.

A second case: an asset held for sale is measured differently

The two-step test applies to assets held and used. Once an asset meets the six held-for-sale criteria of ASC 360-10-45-9, it is measured instead at the lower of its carrying amount and fair value less costs to sell, and depreciation stops. The same company classified its surplus Elm Street warehouse as held for sale on 1 September 2025:

Elm Street warehouse, 1 September 2025
ItemAmount
Carrying amount (land 300,000 + building 480,000)780,000
Fair value1,150,000
Costs to sell (6%)69,000
Fair value less costs to sell1,081,000

Fair value less costs to sell exceeds the carrying amount, so no loss is recorded and the warehouse stays at 780,000. Depreciation stops from 1 September (6,000 a month, 24,000 to December had the building been kept), and the sale in December produced a gain of 301,000. Had fair value less costs to sell been 700,000, the company would have recognized an 80,000 loss on classification, with no undiscounted screen in between.

The trap: testing the whole plant as one group because its total cash flows look healthy. The group is the lowest level of independent cash flows. A dedicated line inside a profitable plant is tested on its own.

Takeaway

Free Excel template: Fixed Asset Register and Depreciation Workbook (depreciation methods, capitalized interest, impairment test, ARO and roll-forward).

Also on this site: how to set a capitalization threshold · how to calculate an asset retirement obligation.

Questions readers ask

What is the difference between the ASC 360 recoverability test and the impairment loss?

The recoverability test compares the carrying amount of the asset group with its undiscounted future cash flows and decides whether there is an impairment at all. If the group fails, the loss is measured separately, as the excess of the carrying amount over the group's fair value.

How often must long-lived assets be tested for impairment under ASC 360?

Only when events or changes in circumstances indicate that the carrying amount may not be recoverable. There is no annual test for property, plant and equipment, unlike goodwill and indefinite-lived intangible assets.

Can an impairment loss on property, plant and equipment be reversed?

Not under US GAAP. The written-down amount becomes the new cost basis. Under IFRS, IAS 36 requires a reversal for assets other than goodwill when the recoverable amount increases, up to the carrying amount that would have existed without the impairment.

Is goodwill tested before or after long-lived assets?

After. Long-lived assets of an asset group are tested under ASC 360 first, and the goodwill of the reporting unit is then tested under ASC 350 using the carrying amounts after any impairment.

Sources: FASB Accounting Standards Codification, Topic 360 and Subtopics 410-20 and 835-20 (paragraphs cited in the text); Treas. Reg. 1.263(a)-1(f). Figures computed by the author's model and checked on 18 November 2026. Education only, not accounting or tax advice.

Read the whole case

This article is one calculation from The Fixed Asset Accounting Handbook. The book follows one manufacturer's fixed assets through a year, from the capitalization policy to the year-end roll-forward, and every figure it prints is a live formula in the free workbook.

Get the PDF edition, $19.99 Paperback · Free companion files